track ballast light gray for crossing K1 TT

Model: TT gauge. track ballast light gray for crossing K1 TT.
With Styrostone®-Gleisbettung it is possible the tracks of the TT model track system quickly einzuschottern. The system offers several advantages: prototypical relevant material: macadam, fast processing by pressing the tracks, no nails, no glue or glue on the track, tracks can be taken out again, very good noise insulation, easy workability of Bettungskörper with a craft knife
. The bedding is made in sheet-track pieces and lines without slope, so that several parallel tracks can be laid together. The batter is prepared in the basic body and can be removed with a cutter to represent single track lines. With the extra available macadam areas can be sprinkled between the tracks and beside the gravel bed. Separate embankment strips allow the repair parts and cutback in underground operator of the points the distance of the field for the point machines. An additionally glued under the track curves strip enables the realistic superelevation of the track in the bends. The installation of the ballast is very simple. The tracks are pressed into the bedding and Styropal contact adhesive to the underside of thin Gleisbettung applied. After about 15-20 minutes drying time the track bed is firmly pressed. (The contact pressure determines the adhesion!) Work equipment must be cleaned immediately after use with water."