Elite track ballast dark brown H0 / H0m left turn

Model: HO HOm gauge. With the Styrostone-Gleisbettung® it is possible to ballast the tracks of the Tillig H0-Elite-Track system quickly and prototypically. The advantages of this system are: prototypical material: stone gravel, quick processing by pressing in the tracks, no nails, no glue or glue on the track, the tracks can be removed again, no migration of the plasticizer components of the sleeper tape and the track bed base, therefore extremely durable, very good Noise insulation, easy workability of the bedding with a craft knife.
The bedding is made for curved track sections and straight lines without an embankment, so that several parallel tracks can be laid next to one another. The embankment is prepared in the base body and can be detached with a hobby knife to show single-track routes.
The stone gravel can be used to sprinkle areas between the tracks and next to the gravel bed. Separate embankment strips allow the repair of cut parts and, in the case of underfloor drive of the switches, the removal of the field for the switch drives. An additional strip glued under the curved track enables the tracks to be raised realistically in the curves.
Laying the ballast bedding is very easy. The tracks are pressed into the bedding and a thin layer of Styrofoam contact adhesive is applied to the underside of the track bedding. After a drying time of approx. 15-20 minutes, the track bed is firmly pressed on. (The contact pressure determines the adhesive strength!) Work equipment must be cleaned with water immediately after use.